7-18
6 Serial Data message definitions
The messages that are used for the Displays are defined in section 11. Please consult
this for complete message definitions.
7 Technical data
Powering
Input voltage: 10 - 32 VDC (12 to 24 VDC nominal)
Current: Maximum 200 mA at 15VDC, typical 100mA
Power Consumption: Maximum 3 Watt, typical 1.5 Watt
Environmental conditions
As required by IEC 60945 4
th
edition. If panel mounted on a watertight flat surface or
in a BULKHEAD M BOX “exposed” category id fulfilled, otherwise “protected”
category.
Watertight as required by IEC 529 category IP66 if mounted in BULKHEAD M BOX,
or panel mounted on a flat surface.
Compass safe distance: 0.3m
Nominal viewing distance
- Fixed information printed on the front foil: 1m
- Speed windows: 3.7m
- Small font in Mode window: 2.7m
- Large font in Mode window: 6.2m
Inputs and outputs
Serial: Isolated IEC61162-1 (NMEA 0183) standard input.
Standard IEC61162-1 (NMEA 0183) output, based on RS485 driver
Remote inputs: 3 inputs with internal pull-up to +5V, activated by grounding to 0V.
+5VDC output: One output with 35mA current capacity.
Connections
Connections of power, inputs and output are done via a 10-pole plug-in terminal,
maximum cable area 1.5 mm².
Dimensions
144 x 144 x 15 mm, mounts in a defined panel cut-out with screw holes pattern.
To Next Page
Loading...