JRC JLN-900 - Control Unit, NCM-1180

7-28
12.4 Control Unit, NCM-1180
Reset
Trip
Mode
WT
Trip/
Total
Press
2 sec
-
DIM
Test
+
é Cons ilium
U/N 704130
113
144
48
24
The Control Unit is used to access the NWW-82 Main Display buttons from a remote
position.
Menu LP5 EXTERNAL INPUTS shall be set to [SDR2] for the remote control to
function correctly (See 6. Set-up of Display
Note! The Control Unit is not intended for e.g. calibration and only for the NWW-82
Main Display.
12.4.1 Installation
Displa
y
Control Unit Function
Terminal 6 Terminal 1 Control Unit (IN 1)
Terminal 7 Terminal 2 Control Unit
(
IN 2
)
Terminal 8 Terminal 3 Control unit
(
IN 3
)
Terminal 4 Not used
Terminal 9 Terminal 5 0 VDC
Terminal 10 Terminal 6 10..32 VDC (12 to 24 VDC nominal)