JRC JLN-900 - 10 Standby STW

7-23
10 Standby STW
This function can be used to temporarily de-activate speed information from the STW
speed log.
To utilize the Standby function the Display has to be connected with two-way NMEA
communication to the speed log system such as the Speed Log Master Display.
Set the local Menu LP2.23, STANDBY STW, to ON.
WARNING: the Standby mode is not valid for normal operation.
The Standby mode must only be used for special purposes.
Note! The software in the WTU (Water Track Unit) has to be 700210E2 or later.
Use the Mode button to toggle until the MODE WINDOW shows;
STW ACTIVE
[-+] FOR STANDBY
Press and release both DIM buttons simultaneously to de-activate the STW
speed log.
When the STW speed log is de-activated the MODE WINDOW shows:
STW DEACTIVATED
ANY KEY TO START
To start/activate the STW speed log, press any key.
If the Display MODE WINDOW shows:
STW UNIT STANDBY
NOT POSSIBLE
Display did not establish contact with the STW speed log (Sig.Processor) due to older
software in the WTU and/or that the Display is not connected with two-way
communication to the JLN-900 Speed Log system.