4-9
Tools/Material recommended for normal
installation/service/maintenance.
Listed as follows from left to right on above picture:
1 pc 55 mm width spanner/wrench (Transducer upper end)
1 pc 46 mm width spanner/wrench (Connecting Tube nut)
1 pc 40 mm width spanner/wrench (Cable Gland)
2 pcs 24 mm width spanner/wrench (Flange screws/nuts)
1 pc 17 mm width spanner/wrench (Tube Bracket screws)
1 pc 35 mm width adjustable spanner/wrench (Extra)
1 pc polygrip plier (Extra)
1 pc external circlip plier, max. tip diameter 2 mm (Tube Locking washer/Circlip)
1 pc straight bar 0.5 – 1 m length, approx. 15 x 15 mm (Recommended for alignment)
1 pc scraper/knife for eventual flange gasket removal (Not at initial installation)
1 pc screw driver, edge 2.5 x 14 mm (Guide Ring screws)
1 pc rope/sling (For Tube/Transducer/Valve Cover assembly lifting/hoisting)
1 pc measuring tape/ruler (For Tube height reference measurement)
Vaseline/Silicone Grease or similar (For lubrication of Lip Seals/Tube)
Insulation tape (For cable termination end wrapping/protection)
Not shown on picture:
Plastic/Wooden scraper tool or cloth/rag (For careful removal of marine growth on
Transducer sensor surface).
1 pc torque wrench (scale: 35, 57 & 150 Nm) M10, M12 and M16 nuts.
Loctite® 243 or similar (studs into flange)
MoS2 grease as needed (For lubrication of stainless steel screws/nuts)
To Next Page
Loading...