4-16
Transducer and Valve Cover Assembling
The Assembly consists of:
x Transducer with cable (30/40 m)
x Valve Cover with:
- Connecting Tube with sealing items.
- Tube Bracket with mounting items.
Assemble as follows:
1. The Valve Cover shall not yet be mounted on the Sea Valve.
x Check that the two Lip Seals are correctly mounted inside the top end of the
Valve Cover. Normally mounted from factory.
x Assure Lip Seals to be clean and free from particles/dirt.
x Slightly lubricate the Lip Seals with Vaseline®, Silicone grease or similar.
2. Mount the Cable Gland on the Connecting Tube.
Cable Gland mounted
3. Gently push the Connecting Tube through the Valve Cover top end.
Note: It is important that the Connecting Tube is inserted from top end of the Valve
Cover. Never try to insert the opposite way, will damage the Lip Seals.
Connecting Tube inserted
To Next Page
Loading...