4-18
Cable Gland mounted and cable passed through
6. Remove the Transducer transport protection.
Note: From this point and forward in the instruction the Transducer Head must be
handled with proper care not to be damaged.
7. Push the Transducer onto the Connecting Tube checking carefully that the Slot in the
Connecting Tube is correctly aligned with the Guide Pin in the Transducer.
8. Engage the Nut in the Transducer threads (only possible when Slot and Guide Pin are
aligned!) and firmly tighten the Nut.
9. Securely tighten the Cable Gland around the cable.
Transducer and Connecting Tube assembled
10. Push the Transducer/Tube assembly completely into the Valve Cover.
Do not rest the Transducer on its sensor surface!
To Next Page
Loading...