To Next Page

To Previous Page

5-33

5.4.4 Demo

Selecting DEMO from the "5.4 Maintenance Menu" displays the settings screen.

1. Press the key, and use the keys to enter a value.

2. Pressing the key displays START . Press the key again.

3. A message is displayed. Select YES , and press the key.

Note that if an external device is

connected, demo data is sent to the

external device.

• Press to return to the Main Menu.

• A demonstration is performed by the sensor, and the data received from the sensor is

displayed, so the demo cannot be run unless the sensor is connected.

• During the demo, DEMO blinks at the bottom of whichever screen is displayed.

• To stop the demo:

a) Turning the unit off restores the unit to normal operation when the power is turned

back on.

b) Select STOP on the demo settings screen.

Demo Settings Menu

Memo

Procedure

Demo Type

1: Right turn

2: Left turn

3: Manual

4: Meandering

5 and over are

disabled

Questions and Answers:

Need help?

Do you have a question about the JRC JLR-20 and is the answer not in the manual?

JRC JLR-20 Specifications

General