3ņ33
VRM2 Operation
If VRM1 is selected or VRM2 is not displayed, press [VRM2] key to select VRM2 before starting
operation.
(The currently selected VRM is shown in reverse video at the upper right of the radar display.)
Procedure 1 Press [VRM2] key.
VRM2 at the upper right of the radar display will be shown in reverse video, and VRM2
becomes operable.
2 Press [VRM2] key again.
The VRM2 display will disappear.
* Software button Õ¸ located at the top right corner of the radar display described in Section 2.3.3 is also
available to switch VRM2 between ON and OFF.
To Next Page
Loading...
Need help?
General
