3ņ5
3.1.5 End the Operation and Stop the System
Exit 1 Press [STBY] key.
The radar will stop transmission and the antenna will stop rotating.
TRANSMIT at the upper left of the radar display changes to STANDBY .
Maintain the standby state if radar observation is restarted in a relatively short time.
Only pressing the [TX/PRF] key starts observation.
2 Press the [STBY] key and the [TX/PRF] key together.
The system will be turned off.
When conducting maintenance work, make sure to turn
off the power and unplug the power connector J1 of the
radar process unit so that the power supply to the
equipment is completely cut off.
Some equipment components can carry electrical
current even after the power switch is turned off, and
conducting maintenance work without unplugging the
power connector may result in electrocution,
equipment failure, or accidents.
Warning
To Next Page
Loading...
