ņ41
z The operation above is effective only for active
targets.
5.3.5 Deactivating AIS Targets (Deactivate AIS)
Deactivate an AIS target
*2
and clear the display of the vector and HL.
Procedure 1 Press the CURSOR button at the upper right of the radar display
several times until CANCEL appears.
The cursor mode is set to the deactivation mode.
2 Move the cross cursor mark onto the active AIS target that is to be
deactivated
*2
, and press [ENT] key.
The selected AIS target will be deactivated
*2
.
Alternative 1 Press the CURSOR button at the upper right of the radar display
several times until ACT AIS appears.
The cursor mode is set to the AIS activation mode.
2 Move the cross cursor mark onto the inactive AIS target that is to be
activated
*1
, and press [CLR/INFO] key.
The selected AIS target will be deactivated
*2
*2
For deactivation of targets, refer to “Types and Definitions of AIS Target Symbols” in Section 5.1.2
“Definitions of Symbols.”
Attention
To Next Page
Loading...
