JRC JMA-5322-6HS - Operation on Numeric Value, Latitude; Longitude and Character Input Menu

3.3 Operation Procedures
y
y y
3.3.4 Operation on Numeric Value, Latitude / Longitude and
Character Input menu
When a numeric value, latitude / longitude, or character must be entered during operation, the input
screen will appear. Enter a numeric value, latitude / longitude, or character according to the
procedures below.
Numeric value input menu
3
Directly entering a numeric value
Procedures 1 On the numeric value input menu, sequentially press numeric keys to
enter a desired numeric value.
For example, when entering 123.4 ° for a bearing value, sequentially press the keys as
follows:
[1] → [2] → [3] → [4]
2 Make sure that the entered value is correct, put the cursor on ENT ,
and then press the [ENT] key.
The set value is reflected to the operating state.
3 To cancel input, put the cursor on CLR , and then press the [ENT]
key.
The numeric value input menu will close without reflecting the set value to the
operating state.
3-16