7.2 Settings
yyy
yyyy
[I] Network Function Setting (Network Function)
Turning on/off the network function.
Procedures 1. Open the Serviceman Menu.
2. Open the Network Function menu by performing the following menu
operation.
2. Installation Menu
→ 9. Next
→ 4. Network
3. Set the Network for the item 1. Network Function in the menu.
On : The network function is operated.
Off : The network function is stopped.
[II] Sensor Priority Setting (Sensor Priority)
The system can receive data from 2 sensors. If the same sentences are received from 2 sensors, the system
use primary system's data.
Procedures 1. Open the Serviceman Menu.
2. Open the Sensor Priority Setting menu by performing the following
menu operation.
7
2. Installation Menu
→ 9. Next
→ 4. Network
→ 3. Sensor Priority
3. Select sensors for 1.primary and 2.Secondary .
Default
1. Primary : No.1 ECDIS
2. Secondary : No.2 ECDIS
Available sensors
No.1 ECDIS
No.2 ECDIS
No.3 ECDIS
No.4 ECDIS
No.1 MFD
No.2 MFD
No.3 MFD
No.4 MFD
No.1 FFD
No.2 FFD
No.3 FFD
No.4 FFD
No.1 Chart RADAR
No.2 Chart RADAR
No.3 Chart RADAR
No.4 Chart RADAR
Conning Display
No.1 Converter Unit
No.2 Converter Unit
No.1 Alart I/F
No.2 Alart I/F
Port Conning
STAB Conning
No.1 Data Server
No.2 Data Server
Console Conning
NAV W/S
No.1 GPS
No.2 GPS
No.3 GPS
No.1 Remote GPS
No.2 Remote GPS
No.3 Remote GPS
None
â…°
i : if you selected "None", the system does not receive data.
7-24
To Next Page
Loading...
Need help?
General
