JRC JMA-9133-SA - Page 36

3.10.2 Load Operating State (Load User Setting) ................................3-119
3.10.3 Delete Operating State (Delete User Setting) ...........................3-119
3.11 USING CARD .....................................................................................3-120
3.11.1 Operate File on the Card (File Manager) ...................................3-120
3.12 RECEIVE PORT SETTING .................................................................3-127
3.12.1 Receive Port Setting (RX Port) ...................................................3-127
SECTION 4
MEASUREMENT OF RANGE AND BEARING
4.1 USE OF NAVIGATION TOOLS ..............................................................4-1
4.1.1 Using Cursor (Cursor) ....................................................................4-2
4.1.2 Using Range Rings (Range Rings) ................................................4-2
4.1.3 Using Electronic Bearing Line (EBL1/EBL2) ................................4-3
4.1.4 Using Parallel Index Lines (PI Menu) .............................................4-8
4.1.5 Operating EBL Maneuver Function (EBL Maneuver Setting) ....4-14
4.1.6 Operating EBL, VRM, and PI with Cursor ...................................4-16
4.2 MEASUREMENT OF RANGE AND BEARING ....................................4-19
4.2.1 Measurement with Cursor Position (Cursor) ..............................4-20
4.2.2 Measurement with Electronic Bearing Line and Variable Range
Marker [EBL] [VRM] .....................................................................4-20
4.2.3 Measurement with Two Arbitrary Points .....................................4-21
SECTION 5
OPERATION OF TARGET TRACKING AND AIS
5.1 PREPARATION ......................................................................................5-1
5.1.1 Collision Avoidance ........................................................................5-2
5.1.2 Definitions of Symbols ...................................................................5-5
5.1.3 Radar Display ..................................................................................5-9
5.1.4 Cursor Modes (Cursor) .................................................................5-11
5.1.5 Setting Collision Decision Criteria ..............................................5-13
5.1.6 Setting Vectors (Vector Time) ......................................................5-14
5.1.7 Setting the GPS antenna location ................................................5-14
5.2 TARGET TRACKING OPERATION .....................................................5-15
5.2.1 Acquiring Target [ACQ] ................................................................5-15
5.2.2 Canceling Unwanted Tracked Targets [ACQ CANCEL] .............5-17
5.2.3 Tracked Target Data Display [TGT DATA] ..................................5-18