JRC JMR-5410-6XH - Changing the Bearing;Interval of Parallel Index Lines in the Operation Unit (All Mode)

4-17 Section 4 Range and Bearing Measurement Methods
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
4.6.3.1 Changing the bearing/interval of parallel index lines in
the operation unit (All mode)
[Changing the bearing with index line 1]
When index line 1 is clicked on, the shape of the cursor changes to .
All the index lines rotate centring on the index line reference position (starting point).
[Changing the bearing at a clickable trisectional end segment position of index lines 2 to 8]
When one of the index lines 2 to 8 is divided into three equal segments and the mouse button is clicked
on both ends of the line segments, the cursor shape changes to .
Index lines 2 to 8 move, forming a circle centring on the reference position while the index line
reference position (starting point) is fixed.
[Changing the interval at a clickable trisectional centre segment position of index lines 2 to 8]
When one of the index lines 2 to 8 is divided into three equal segments and the mouse button is clicked
on the middle line segments, the cursor shape changes to .
Index lines 2 to 8 move in parallel to index line 1.
Memo
If a clickable segment is 2 cm or less, the change of interval mode is always activated.
Change of
angle
Change of
angle
Change of
angle
Dividing the line segment that can be clicked into 3 equal sections
CCRP is the
reference point
Index line 1
Index line 2 to 8