JRC JMR-5410-6XH - Using the Cursor; Using the EBL;VRM Dial for the Setting

6-21 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.5.2.2 Using the cursor
1
Select AZ ([Use AZ1] or [Use AZ2]) to be set.
2 Click on the starting azimuth position.
The starting azimuth is set.
3 Move the cursor and click on the ending azimuth position.
A line connecting the starting azimuth and the ending azimuth is displayed.
4 Move the cursor and click at the start distance position.
An arc appears at the start distance position.
5 Move the cursor and click at the end distance position.
This creates an automatic acquisition/activation zone (AZ) of fan shape that is enclosed by the
starting azimuth, the ending azimuth, and the ending distance.
6.5.2.3 Using the EBL/VRM dial for the setting
1
Select AZ ([Use AZ1] or [Use AZ2]) to be set.
2 Click on the [Make AZ1] button or the [Make AZ2] button.
The cursor enters the AZ creation mode.
3 Set [Start Angle] by turning the EBL dial.
4 Set [Start Distance] by turning the VRM dial.
5 Press the EBL dial and the VRM dial.
6 Set [End Angle] by turning the EBL dial.
7 Set [End Distance] by turning the VRM dial.
8 Press the EBL dial.