Section 13 Setting up the Operation Mode 13-12
13.7 Setting Radar Antennas
Set radar antennas.
[Operation procedure]
Open the antenna setting screen by performing the following menu operations.
[Menu] button
→ Settings → TXRX
PRF Fine Tuning
You can reduce the setting value of the repetition
transmission frequency by 0.2% (maximum
value is 0).
0 to 31
Stagger Trigger
Select On/Off of the Radio Wave Interference
Reduction function.
It is not displayed when a solid state radar
antenna is connected. The previous setting value
is maintained, however.
To enable: Select.
To disable: Clear.
PRF Set up the operation mode of the transmitter's
repetition transmission frequency.
[Economy] is not displayed when a solid state
radar antenna is connected. If a solid state radar
antenna is connected while an operation mode is
being specified, the setting will be reset to the
default value.
Normal / Economy /
High Power
Ice Class Standby
Mode
Turn On/Off the Ice Class Standby mode. To enable: Select.
To disable: Clear.
• If a small solid state radar antenna is connected, the setting in [Stagger Trigger] will not be
saved and it will turn On (its check box is already selected) at each startup.
• When a new antenna (NKE-2255) is connected, the [REF] combo box is not displayed.
To Next Page
Loading...
