Appendix C Setting the Inter switch C-6
C.2.4 Changing the connection pattern
1
Click the "Change Inter switch connection" button.
The [Inter Switch] dialogue box is displayed.
2 Click the Master or Slave display unit selection button to be connected to the radar
antenna.
The selected display unit is highlighted.
3 Place the cursor to the destination of change and click it on.
The currently selected display unit and the change destination display unit are interchanged.
4 If necessary, carry out the steps 2 and 3 for other display units.
5 Click the [Set] button.
The information of the set connection pattern is transmitted to the Inter switch.
6 Click the [×] button.
The [Inter Switch] dialogue box is closed.
C.2.5 Changing the name of radar antenna or display unit
1
Click the [Edit name] button of the [Inter Switch] dialogue box.
The [Edit name] dialogue box is displayed.
2 Click the name of the radar antenna or the display unit whose name is to be edited.
A software full keyboard is displayed.
3 Change the name.
The name can be input by using 1 to 8 alphanumeric characters and symbols.
4 Click the [Set] button.
The name is changed.
5 Click the [×] button.
The [Edit name] dialogue box is closed.
To Next Page
Loading...
