JRC JMR-5482-S - Setting the Offset Amount that Is Input in the [Enter Offset] Dialogue as the Offset Position; Setting the Position on the Chart on Which the Mouse Button was Clicked as the Offset Position

4-31 Section 4 Range and Bearing Measurement Methods
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
4.8.2 Setting the offset amount that is input in the
[Enter Offset] dialogue as the offset position
1 Click on the [Enter Offset] button of [Position].
The [Enter Offset] dialogue is displayed.
2 Select Input box, then use the displayed software keyboard to enter an offset amount
of the latitude.
3 Select Input box, then use the displayed software keyboard to enter an offset amount
of the longitude.
4 Click on the [OK] button.
The offset amount that was input is set as the offset position.
4.8.3 Setting the position on the chart on which the
mouse button was clicked as the offset
position
1 Click on the [Enter Position] button of [Position].
The [Enter Position] dialogue is displayed.
While the dialogue is displayed, the cursor changes to the offset cursor and the mode changes
to the position selection mode.
2 The position is displayed in [Position] in the dialogue as the coordinate of the position
on the chart on which the mouse button was clicked.
Memo
Post-offset coordinates can also be input from the software keyboard.
3 Click on the [OK] button.
The coordinate is set in the offset position.