JRC JMR-5482-S - Maintenance; Managing Storage; Maintaining the Radar

14-21 Section 14 Adjusting and Setting up Equipment (for Services)
1
14
14.4 Maintenance
Use the [Maintenance] dialogue for maintenance operation of this equipment.
14.4.1 Managing storage
[Operation procedure]
Open the information display screen by performing the following menu operations.
[Menu] button → Service → Maintenance → Information
[Storage] tab
The total storage capacity and available capacity of drive (C:) are displayed in the [Drive Information]
list.
The [File Information] list shows the size of each file that is stored in the data folder. The information is
available for the files that are managed under [File Manager].
[Hardware] tab
The MAC address is displayed.
14.4.2 Maintaining the radar
Use the [RADAR] dialogue to maintain the radar.
[Operation procedure]
Open the [RADAR] dialogue by performing the following menu operations.
[Menu] button → Service → Maintenance → RADAR
14.4.2.1 Changing the operation mode of the safety switch
Open the list of the [Safety Switch] box and select the operation to be performed when the safety
switch of the radar antenna is set to OFF.
Setting
Operation
TX-Off • No radiant section's rotation and transmission
• PPI screen in the transmitting state
• Maintains the transmitting state without generating BP or BZ alarm
Standby • No radiant section's rotation and transmission
• PPI screen standby
TX-On • No radiant section's rotation, with transmission
• PPI screen in the transmitting state
• Maintains the transmitting state without generating BP or BZ alarm