JRC JMR-5482-S - Setting GPS

13-25 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
13.18 Setting GPS
Set a GPS receiver.
[Operation procedure]
Open the GPS receiver setting screen by performing the following menu operations.
[Menu] button → Settings → GPS
The items that are displayed vary depending on the version of GPS that is installed.
The following table shows the setting items.
Setting Item
Description of Setting
Setting Value
Position Enter a position of own ship. 0°00.00’ ~ 81°00.00’N/S
0
°
00.00’ ~ 180
°
00.00’E/W
Exclusion Satellite Enter a satellite number that is to be prohibited
from use. This item is displayed only for the GPS
of Version R29.xx and earlier versions.
0 ~ 32
Geodetic Datum Select a geodetic datum. 0 ~ 8, 11 ~ 47
(Example) 0: WGS-84
Antenna Height Enter an antenna height. Integer within the range
from to 8191
Fix Mode Set a position fixing mode.
2D: Use when obtaining position information
from 3 satellites only by assuming the altitude.
3D: Use when obtaining position information
from four or more satellites.
2D / 3D / AUTO
DOP Level Set a HDOP level.
The lower the value, the higher the precision
becomes and the higher the value, lower the
precision becomes.
Up to 4 / Up to 10 / Up to 20
Position
Averaging
Set a position averaging level.
The display item and input range vary
depending on the GPS version.
~R26.00 : Combo box
R26.01 ~ 39.99 : Numeric value input box
R40.00~ : Numeric value input box
(Position/Speed/Course)
<~R26.00>
Short / Standard / Long
<R26.01 ~ 29.03>
1 ~ 99 sec
<R29.04 ~ 39.99>
0 ~ 99 sec
<R40.00 ~>
0 ~ 99 seconds
Elevation Mask Limit the satellites to be used according to the
elevation angle.
Integer between 5°~ 89°
RAIM Level Set a precision of RAIM that can be used.
This item is displayed only for GPS Version
R39.00 and later versions.
Off / 10 m / 30 m / 50 m /
100 m