JRC JMR-5482-S - Data Backup;Restore; Backing up Data

15-45 Section 15 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
24
26
27
15.8 Data Backup/Restore
Do not turn off the power supply during backup/restore.
Otherwise, a function fault occurs, leading to the possibility of an accident.
15.8.1 Backing up data
To maintain customer data, back up the data regularly by using the following procedure.
Connect an external medium such as a USB memory device for backup.
1 Press the Power supply button of the operation unit.
The power supply button is lit. Then, the Mode Selection screen is displayed.
2 Click on the [Data Backup/Restore] button on the Mode Selection screen.
The [Backup/Restore] dialogue is displayed.
3 Click on the [Data Backup] tab.
4 Select a drive of the data backup destination from the drive selection combo box.
5 Click on the [Start] button.
A confirmation dialogue is displayed.
6 Click on the [OK] button.
Copying of data to the backup destination that is selected in the drive selection combo box
starts.
Memo
Do not perform any other operations until backup is completed. Otherwise, backup may fail.