JRC JMR-5482-S - Adjusting a Performance Monitor of a Solid State Radar (NKE-1632;2632)

14-9 Section 14 Adjusting and Setting up Equipment (for Services)
1
14
14.2.3.4 Adjusting a performance monitor of a Solid State Radar
(NKE-1632/2632)
Use the [Performance Monitor (SSR)] dialogue.
Perform the following adjustments based on the transmitting/receiving attenuator value as the
reference.
Memo
Do not change the values that are set in the [Monitor Range] input box and the [RX Monitor Gain]
input box.
Adjusting a monitor reception level
Adjust the circuit for monitoring the radar equipment reception performance.
1 Click on the [Monitor Sector] (transmission monitor timing adjustment value) input
box.
A numeric value input keyboard is displayed.
2 Input a setting value in the input box so that the maximum value is displayed in [RX
Level] (received signal attenuation value).
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".
3 Click on the [RX Monitor Adjustment] (received signal monitor adjustment value).
A numeric value input keyboard is displayed.
4 Input a setting value (0 to 127) so that [0.0±1.0dB] is displayed in [RX Level] (received
signal attenuation value).
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".
Adjusting a monitor transmission level
Adjust the circuit for monitoring the radar equipment transmission performance.
1 Click on the [TX Monitor Adjustment] (transmission signal monitor adjustment value)
input box.
A numeric value input keyboard is displayed.
2 Input a setting value in the input box so that [0.0±1.0dB] is displayed in [TX Level]
(transmission signal attenuation value). (0~127)
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".