JRC JMR-5482-S - Displaying a TT Limit Ring; Setting a Gate Size Used for Tracking; Setting a Quantization Level at Automatic Acquisition; Setting a Quantization Level at Manual Acquisition

Section 14 Adjusting and Setting up Equipment (for Services) 14-12
14.2.5.2 Setting a quantization level at manual acquisition
The quantization level and the tracking performance must not be changed
unnecessarily since the optimum values are set.
Otherwise, the performances of
the target tracking function may be affected and an accident may occur.
1 Click on the [VD Level (Manual) ] (quantization level at manual acquisition) input box.
A numeric value input keyboard is displayed.
2 Enter a setting value in the input box. (0 to 255)
For the method of using the numeric value input keyboard, refer to “3.19.2 Name and function
of each section of the keyboard”.
14.2.5.3 Setting a quantization level at automatic acquisition.
The quantization level and the tracking performance must not be changed
unnecessarily since the optimum values are set.
Otherwise, the performances of
the target tracking function may be affected and an accident may occur.
1 Click on the [VD Level (AUTO) ] (quantization level at automatic acquisition) input box.
A numeric value input keyboard is displayed.
2 Enter a setting value in the input box. (0 to 255)
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".
14.2.5.4 Setting a gate size used for tracking
1
Select a gate size from the [Gate Size] combo box.
• Small
• Medium
• Large
14.2.5.5 Displaying a TT limit ring
1
To display a TT limit ring, select the [Limit Ring] check box.