JRC JMR-5482-S - Page 398

Section 13 Setting up the Operation Mode 13-26
Setting Item
Description of Setting
Setting Value
GNSS Select a system to be used from GLONASS,
BDS, and QZSS.
However, a combination of GLONASS and BDS
is not allowed.
This item is displayed only when the GPS
Version is R41.00 or a later version and the
satellite type is available.
To enable: Select.
To disable: Clear.
Master Reset When this item is enabled and the setting value
is transmitted, the GPS receiver is initialised.
To enable: Select.
To disable: Clear.
Send Data Transmit the setting contents to the GPS
receiver.
During the transmission, “Sending ...” is
displayed as the status. When the transmission
is successful, “Completed” is displayed. When
the transmission failed, “Not Completed” is
displayed.
-