JRC JMR-9230-S3 - Set display of danger detection highlight

16-53 Section 16 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
16.2.15 Set display of danger detection highlight
When you select [Graphical Indication] in the classification pane, the [Graphical Indication] dialog box
appears in the edit pane.
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Graphical Indication for
the Charted Feature
object
Select and enable the highlighting function of the
detection object on the chart
To enable: Select.
To disable: Clear.
Crossing Safety
Contour
Activate the partial highlight display function of the
object where the execution result of Safety Check
becomes Crossing Safety Contour error.
To enable: Select.
To disable: Clear.
Navigational Hazards Activate the partial highlight display function of the
object where the execution result of Safety Check
becomes Navigational Hazards error.
To enable: Select.
To disable: Clear.
Prohibited Areas and
Areas with Special
Conditions
Prohibited Area or Areas with Special Condition
activates the partial highlighting function of the error
part.
To enable: Select.
To disable: Clear.
Settings for
Depth/Safety Contour
Click to open the Depth / Safety Contour screen of the
Alert setting.
Settings for
Look-ahead
Click to open the Look-ahead screen of the Alert
setting.
Settings for Special
Condition Area
Click to open the Special Condition Area screen of the
Alert setting.