Section 18 Setting up the Operation Mode 18-12
Setting Item Description of Setting Setting Value
Trails Reduction Set up the radar trail reduction processing
level. The higher the level gets, the
stronger the reduction processing level
becomes.
Off
Level1(Wide)
Level2
Level3(Narrow)
MAX Length Select the maximum value of the time to
display radar trails.
Short
Long
Trails Length Set up the interval for displaying radar
trails.
<When Short is specified>
Off/15s/30s/1 min/3 min/
6 min/10 min/15 min/30 min/60
min
<When Long is specified>
Off/30 min/1 hour/2 hour/3
hour/…(thereafter, at intervals
of 1 hour)…/24 hour
Gain Offset Set up the gain offset for sensitivity
compensation.
-32 to 32
PRF Set up the operation mode of the
transmitter's repetition transmission
frequency.
[Economy] cannot be selected when a
S-band solid state radar antenna is
connected. If a S-band solid state radar
antenna is connected while [Economy] is
being selected, the setting will be reset to
the default (factory preset) value.
[Economy] and/or [High Power] cannot be
selected when a X-band splid state radar
antenna is connected. If X-band solid state
radar antenna is connected while
[Economy] and/or [High Power] is being
selected, the setting will be reset to the
default (factory preset) value.
Normal
Economy
High Power
Small Buoy Detection Turn On/Off the small target detection
mode.
To enable: Select.
To disable: Clear.
Fishnet Detection Turn On/Off the fishnet detection mode. To enable: Select.
To disable: Clear.
Antenna Height Set up the radar antenna height.
When this is set to [Default], the value that
has been set in [Antenna Height] by
selecting [Service] - [Adjustment] - [TXRX]
is used.
Default
-5m
5-10m
10-20m
20m-
To Next Page
Loading...
