JRC JMR-9230-S3 - Page 663

18-61 Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Item saved
Preferences save target Factory setting value, value
and action when Set
Default button is pressed
Location Item
EBLs RADAR screen
- EBL/VRM read
information area
RADAR screen -
EBL/VRM read
information area
EBL1 (EBL2)
• Display On/Off
• Control right
• Bearing value
• EBL bearing
True/Relative
(commonly applied to
both EBL1 and EBL2)
EBL1
• Display On/Off: On
• Control right: On
• Bearing value: 000.0
• EBL bearing
True/Relative: True
Parallel index
lines
RADAR screen
- PI (Parallel Index)
RADAR screen – PI
(Parallel Index)
• Display On/Off
• Control right
PI measurement
reference point (blank
space/C/D and floating
position. In the case of
C, the information is
stored in the form of
DC coordinate and in
the case of D, the
information is stored in
the form of
latitude/longitude.)
• Display On/Off: On
• Control right: Off
• Bearing value: 0°
• Interval: 0.5NM
Display for All Lines: On
Mode: All
Unit: NM
Operation Area: One Side
Floating: Off
Heading Link: Off
Reference Bearing: True
Display
mode of the
radar picture
RADAR screen
- Presentation mode
information
• Motion mode
• Bearing mode
True motion
North-up
TM reset position
Stabilization
Sea/Ground
RADAR screen
- Presentation mode
information
• Stabilization mode
(combo box)
GND
Off-centring
RADAR screen
- Presentation mode
information
• Off-Centre
button→Off-Center
On/Off status and
Off-Center DC position
Off-center: Off=On center
Target trails
RADAR screen
- Other ship's information
• Trail true/relative
• Trail length
• Trail true/relative: True
• Trail length: 6min
Past
positions
RADAR screen
- Other ship's information
• Past POSN
Off