JRC JMR-9230-S3 - Page 665

18-63 Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Another default settings (excepts preference) are below.
Default
Setting Item
Default Setting target Factory setting value, value
and action when Set
Default button is pressed
Location Item
Radar image
Overlay
ECDIS－Bottom bar
• Radar Echo Image • Radar echo image: Off
AIS function
button
ECDIS－Bottom bar
• AIS display On/Off • AIS display: Off
TT1/TT2
function
button
ECDIS－Bottom bar
• TT1/TT2 display
On/Off
• TT1/TT2 display: On
Multi View
View
－Multiview
• Multi view window
other than Single View
window
• Multi view window other
than Single View window:
Single View
Edit User
Map
User Map Editor • Edit dialog • Edit dialog: Exit
Edit Manual
Update
Manual Update Editor • Edit dialog • Edit dialog: Exit
Route
planning
Route planning dialog • Edit dialog • Edit dialog: Exit
Route
monitoring
Route monitoring • Route monitoring start
• Route monitoring
dialog
• Voyage Information
• Load latest route plan
• Route monitoring dialog:
Close
•
Voyage Information: Move
to bottom-right
Cursor
Readout
Cursor Readout • Cursor Readout • Move to bottom-right
• Open
MOB
MOB • Cursor Readout • Move to bottom-right
Display of
charts
View
－
Options
－
Chart Display
• Chart Load • AUTO
Chart
Maintenance
Chart Maintenance •
Chart Maintenance
dialog
• Chart Maintenance dialog:
Exit
SelfTest
Maintenance
－
Diagnosis
• Diagnosis dialog • Diagnosis dialog: Exit
CONNING
block
Common Information
Window
• CONNING block
overlay
• CONNING block overlay:
Exit
Chart 1
ECDIS display • Chart drawing
(Chart 1 chart)
• Chart drawing
(Chart 1 chart): Exit