3-1
3
CHAPTER 3. OPERATION
3.1 Basic operation of JUE-95SA
Before turning on power switch of JUE-95SA, confirm all the signal cables and power cables are
connected correctly.
Regarding the details of LED lamp display, switch functions, and connecting cable and connector,
refer table 3.1.1 to 3.1.3.
Carry out Power ON/OFF with the procedure mentioned below.
3.1.1 Power on and log in
Turn ON the power switch of IME, the terminal is logged in to Ocean Region automatically, then
LOG-IN lamp on PANEL is illuminated. (At the first time, it will takes maximum 20 minutes to logged
in after powered on. Normally, it will takes maximum 3 minutes to logged in.)
3.1.2 Log out and power off
Turn OFF the power switch of IME, the terminal is powered off after it was logged out from Ocean
Region, automatically. (It will takes maximum 5 seconds to logged in after powered on.)
3.1.3 Setting of Security Alert
Before security alert transmission, set the destination, message and so on in the setting menu. Refer
to clause 3.2.
3.1.4 Transmission of Security Alert
In case of security alert transmission, press security button. After 30 seconds, security alert is
transmitted. Security alert is transmission on a setup interval until canceled. Refer to clause 3.3.
All LEDs are turned off due to JUE-95SA changed its state to [Security warning transmission
standby
(*1)
], by turns on power source of IME and terminates log-in process.
Press Test button to confirm status of JUE-95SA in this situation
(*2)
.
Press Test button again after you confirmed the status of JUE-95SA, then all LEDs are turned off
again.
(*1) Security warning transmission is transmitted when security button is pressed on this
situation. All LEDs are still turned off during transmission.
(*2) Then LED of Test button and other LED, which corresponding to the state of JUE-95SA
at that time, are lit.
Security warning is transmitted after 30 seconds, when you press Security button on this
status. And LED is lit corresponding to transmitting result.
NOTE
To Next Page
Loading...
