3-3
3
Table 3.1.1 The status of MES which LED lamps indicated
(Number of the button name corresponds to Figure 2.3.2a)
NAME ON OFF
(2) POWER Lamp MES power on. MES power off.
(3) SYNC Lamp Bulletin Board OK.
When the MES is returned the NCS channel
to the TDM channel or the TDM channel to
the NCS channel, this LED is blinking.
Bulletin Board NG.
(4) LOG-IN Lamp Logged in. Logged out.
(5) TRANSMIT Lamp MES carrier on. MES carrier off.
(6) RECEIVE Lamp Message receiving. No message, or message
received and output it to DTE
and/or Printer.
(7) ALARM Lamp
・When TX Alarm *
1
is occurred, it blinks
at intervals of 0.5 seconds.
・When Battery Alarm*
2
is occurred, it
blinks with 1 second interval.
・ When both of TX and Battery Alarms are
occurred, this lamp lights without blink.
・ Security alert is not transmitted even if
the button is pushed, when the bad
connection cannot be recognized.
Normal condition.
（To extinction the lamp,
turn on and off the power
switch.）
*1) TX Alarm informs some sort of malfunction is occurred on communication devices.
*2) Battery Alarm informs the battery is decreased to under the specified level.
Table 3.1.2 Function of switch and buttons
Name Function Remarks
(1) POWER Switch Power ON/OFF the MES.
(8) RESET Button To reset the status of JUE-95SA
when it operates abnormally.
Refer to 4.6 of this manual and be
careful to handle this button.
(It seems as a very little hole. Press
the switch exists in the hole with
narrow object like a wire.)
(9) TEST Button To use for SSAS test transmission.
Table 3.1.3 Connectors and the Cable (Refer 2.3.2b for detail)
Name Connected from/to
EME Connector IME to EME
Power Supply Connector IME to AC adopter of PSU (24V)
DTE Connector IME to DTE and DS/DTE
Option Connector (X5 and X6) IME to Security Button 1/2(X5), and Security Button 3/4(X6)
To Next Page
Loading...
