13
Accessing the System Mode
To enter the System mode, press both the Scroll and
Channel keys at the same time while turning on the
transmitter power switch. By pressing the Scroll key,
you can now choose Model Select, Model Name Input,
Grip button C function or the Data Reset function as
shown here on the System Mode flow chart.
Information for each function is located on the
page number listed next to the function name on
the flow chart.
To exit the System mode, press the Scroll and
Channel keys at the same time or simply turn off
the transmitter.
Note: If you turn the transmitter off and immedi-
ately enter System mode again, you will be
returned to the last System mode function used
instead of the model select function. While in
System mode, there is no RF output generated by
the transmitter. Adjustments can be performed
with reduced battery power consumption. If you
exit System mode by pressing the Scroll and
Channel key at the same time, RF output will not
be enabled until you first turn off the transmitter.
Model Name Entry
(page 14)
21
md !
1
mdl
1
Model Select
(page 14)
20
clr
1
gbc
0
Data Reset
(page 16)
25
Grip Button C
Function
(page 15)
To Next Page
Loading...
Need help?
General