14
Model Name Entry
(System Mode)
Model Select
(System Mode)
The XR2i has memory for two models. This feature
allows for two different models to be operated with
the same transmitter (additional receivers and servos
must be purchased separately) or one model with
two different race setups.
Accessing the Model Select Function
1. Press the Scroll and Channel keys at the same time
and hold.
2. Turn the transmitter power switch on to enter
System mode.
3. If "MDL" does not appear on the screen, press the
Scroll key until "MDL" appears.
4. Press the Increase or Decrease keys to select the
desired model number (1 or 2).
5. Press the Scroll key to access the Model Name
Entry function.
6. To exit System mode, either turn the transmitter
power switch off or press the Scroll and Channel
keys at the same time.
md !
1
Character to
be Adjusted
Current Model
Number
mdl
1
Model Select
Fuction
Current Model
Number
Press and hold the
Scroll and Channel keys
at the same time while
turning transmitter
power switch on.
Press the Increase
or Decrease keys to
select the desired
model to be used
(1 or 2).
Press and hold the Scroll
and Channel keys at the
same time while turning
transmitter power switch
on. Next, press the Scroll
key until the flashing
“M” appears.
Press the Channel
key to select the
character to be
changed.
Press the Increase or
Decrease keys to
select the correct
letter/number to be used.
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
The XR2i allows a three-character name to be input
for each of the two models available. The current
model with name will then be displayed in the Normal
display screen. This feature is useful to help identify
different models, setups, etc.
Accessing the Model Name
Entry Function
1. Press the Scroll and Channel keys at the same time
and hold.
2. Turn on the transmitter power switch to enter the
System mode.
3. Press the Scroll key until "MD1" appears on the
screen with the first character flashing.
4. Press the Increase or Decrease keys to select the
correct letter/number for the first character (flashing).
5. To change the remaining two characters, press the
Channel key until the desired character to be
changed is flashing.
6. Press the Scroll key to access the Grip Button
C function.
7. To exit the System mode, either turn the
transmitter power switch off or press the Scroll
and Channel keys at the same time.
To Next Page
Loading...
Need help?
General