JTS R-4 - Page 35

31
Receiver channel 1
◎Frequency setting
◎Default group
Spin the rotary switch to select group ''G:'' through 1
to 6: Push the switch to con󺸾rm the selection.
Spin the rotary switch again to select channel
''CH:'' up to 22 channels are available. Push SETUP
to con󺸾rm and save the selection.
Select the left 3 digits of the frequency; spin the
rotary switch to adjust in the increment of ''+/-'' 1
MHz. Push the switch to con󺸾rm the selection.
Select the right 3 digits of the frequency; spin the
rotary switch to adjust in the increment of ''+/-''
0.025 MHz. Push SETUP to con󺸾rm and save the
selection.
◎Channel scan
Scan all
groups
Push the rotary switch to start
scanning. The system goes to the
selection page once the scanning
is done. It is also possible to arrive at
here through menu.
Scan result Push the rotary switch to enter the
selection page and examine the
result. Select an available channel
and push SETUP to save the selection.
Scan current
group
The next group will be scanned every
time the rotary switch is pushed.
Make the selection and push SETUP
to save it.