JTS R-4 - Operation

46
Push and hold SET for 2 seconds to enter the
setting mode. Push SET repeatedly to select
the desired item. Use ▲ / ▼ for parameter
settings. Push SET again to save the change
and exit.
Parameter settings
◎ FREQ: Frequency setting
Increment of 1MHz Select
with▲/▼
Increment of 0.025MHz Select
with▲/▼
◎ GROUP: group/channel setting
G (group) Select default group 1~6
CH (channel) Select default channel(s),
up to 22
6-4 Operation //
Start with group number and then channel
number.
Start with those digits in 1MHz and then
those in 0.025MHz