ATF Instruction Manual
21
4) Cleaning the tape traveling section
Clean any grease or debris that is generated when the carrier tapes slides from the
tape traveling section.
5) Cleaning the cover tape eject section
Use a dry cloth to rub
the eject cover, inner guide, blade base and retaining roller
blade if an adhesive substance is stuck to any of these parts.
To rub the inside of the eject section with a dry cloth, remove the eject cover
setscrew, and then the eject cover.
CAUTION
Rub the eject cover, inner guide, delivery roller blade and blade base with
a dry cloth only. Never use alcohol or IPA (Isopropyl alcohol).
Eject cover setscrew
Eject cover
Retaining roller blade
Inner guide
Blade base
To Next Page
Loading...
