– 82 –
1. Installation of the clamp bar stacker
(1) Let the stacker base fit the frame and fix it with the setscrews
and the washers (in 3 positions).
(2) Determine the fixing size so that the end face of frame’s vertical strut
and that of the stacker base are separated by 30.5mm, as
illustrated.
2. Stacker support plate and stacker positioning bolt positions
(1) Temporarily fasten the stacker positioning bolt with the frame nut
.
(2) Temporarily fasten the stacker support plate with the setscrews
and the washers (in 4 positions).
3. Stacker unit assembly
(1) Insert the stacker unit in the mounting hole A of the stacker base
.
Adjustment Procedures Results of Improper Adjustment
To Next Page
