– 17 –
❶
❶
❶
❶
❶
❷
(Blue)
❹
(Green)
❺
(Red)
❸
(White)
(1) Installing the connecting rod
1) Move pedal ❸ to the right or left as illustrated
by the arrows so that motor control lever ❶ and
connecting rod ❷ are straightened.
(2) Adjusting the pedal angle
1) The pedal tilt can be freely adjusted by changing
the length of the connecting rod.
2) Loosen adjust screw ❹, and adjust the length of
connecting rod ❺.
27. Adjustment of the pedal
WARNING :
Be sure to turn the power OFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
28. Marker dots on the handwheel
The upper stop position of the needle bar is reached
when marker dot ❶ on the cover is aligned with white
marker dot ❸ on the handwheel.
The operating timing of the thread trimming cam is
when marker dot ❶ on the cover is aligned with red
marker dot ❺ on the handwheel.
❶
To Next Page
Loading...
Need help?
General
