– 24 –
Parame-
ter code
Parameter function Range/ unit Default Key Description
P11 Back-Tacking mode
selection
J / B J Press Back-Tacking switch by hand:
J : It will activate when machine is stopped
or running
B : It will activate only the machine is run-
ning
P12 Start Back-Tacking
mode selection
A / M A Start Back-Tacking, reverse solenoid action:
A : One shot to pedal, it will automatic
execute Start Back-Tacking.
M : Pedal-controlled and motor can stop
arbitrarily
P13 Mode selection at
the end of Start
Back-Tacking
CON / STP CON CON : At the end of Start Back-Tacking,
machine continues sewing if pedal
pressed or START signal on ( standing
operation)
STP : At the end of Start Back-Tacking, ma-
chine stops
P14 Soft start ON / OFF ON Add with full-function operation panel is valid.
ON : Soft start function is turn on.
OFF: Soft start function is turn off.
P15 Setting stitches A of
Start Back-Tacking
1 to 15 Stitches Reserve Invalid,setting by front shortcut key
P16 Setting stitches B of
Start Back-Tacking
1 to 15 Stitches Reserve Invalid,setting by front shortcut key
P17 Setting turns of
Start Back-Tacking
1 to 4 Times Reserve Invalid,setting by front shortcut key
P18 Stitch balance for
Start Back-Tacking
1
0 to 31 6
① 0→15 The action gradually delay
② 16→31 The action gradually advance
③ The action of 0 delay than 16
P19 Stitch balance for
Start Back-Tacking
2
0 to 31 9
P20 Mode selection for
End Back-Tacking
A/M
M End Back-Tacking, reverse solenoid action:
A： Pedal full heeling ,it will automatic ex-
ecute end Back-Tacking
M： Pedal-controlled and motor can stop
arbitrarily
P21 End Back-Tacking
function selection
ON / OFF Reserve Invalid,setting by front shortcut key
P22 Setting stitches C of
End Back-Tacking
1 to 15 Stitches Reserve Invalid,setting by front shortcut key
P23 Setting stitches D of
End Back-Tacking
1 to 15 Stitches Reserve Invalid,setting by front shortcut key
P24 Setting turns of End
Back-Tacking
1 to 4 Times Reserve Invalid,setting by front shortcut key
P25 Stitch balance for
End Back-Tacking 3
0 to 31 12
① 0→15 The action gradually delay
② 16→31 The action gradually advance
③ The action of 0 delay than 16
P26 Stitch balance for
End Back-Tacking 4
12
P27 Adding 1 stitch to
C segment of End
Back-Tacking
ON / OFF ON Adding 1 Stitch to C Segment of End
Back-Tacking
ON : Valid OFF : Invalid
P28 Mode selection for
Bar-Tacking
A/M A Bar-Tacking, reverse solenoid action:
A : One shot to pedal, it will automatic
execute Bar-Tacking.
M : Pedal-controlled and motor can stop
arbitrarily
To Next Page
Loading...
