– 31 –
(3) How to balance stitches for
【
Bar Tacking
】
Press Key to enter
Technician Parameter
Press or key
to get
parameter code P-32, P-33 press
to enter [parameter value]
①
Press , key
to adjust P-32,
P-33 balance stitches properly
②
After adjustment press key
to
save value.
Example： Step 1 : Setting stitch number for Bar-Tacking A=B= 4 and turns of Bar-Tacking D=4
Step 2 : Sewing the pattern in normal speed
Step 3 : If unbalanced situation is appeared please correct it as below:
Suggestion : Select the balance stitches for Section A(1.3) before selecting for B(2.4)
Factory defaults of balance stitches for P-32.BT5 and P-33.BT6 are different because of different
types of machine head.
A
A
A
A
B
B
B
B
B
B
B
B
A
A
A
A
D
D
D
D
Start point
Start point
Start point
Start point
Case 1 : Longer A and shorter B
Adjustment : Please adjust [P-32. BT5] value
suitably.
15⇒ 14⇒ ・・・1 ⇒ 0 ⇒ 16⇒ 17⇒
・・・⇒ 30 ⇒ 31
Case 2 : Shorter A and normal B
Adjustment : Please adjust [P-32. BT5] value
suitably.
31⇒ 30⇒ ・・・17⇒ 16⇒ 0 ⇒ 1 ⇒
・・・⇒ 14 ⇒ 15
Case 3 : Normal A and longer B
Adjustment : Please adjust [P-33. BT6] value
suitably.
15⇒ 14・・・⇒ 1 ⇒ 0 ⇒ 16⇒ 17⇒
・・・⇒ 30 ⇒ 31
Case 4 : Normal A and shorter B
Adjustment : Please adjust [P-33. BT6] value
suitably.
31⇒ 30⇒ ・・・17⇒ 16⇒ 0 ⇒ 1 ⇒
・・・⇒ 14 ⇒ 15
To Next Page
Loading...
Need help?
General
