Remote control
74
IN commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of Cryo-Compact Circulator
Number of software version (V X.xx)
Status message, error message (see page 75)
Heating power being used (%).
Temperature value registered by the external Pt100 sensor.
Temperature value registered by the safety sensor.
IN_PV_04 none Setpoint temperature („SafeTemp“) of the excess temperature
Working temperature „Setpoint 1“
Working temperature „Setpoint 2“
IN_SP_02 none Working temperature „Setpoint 3“
High temperature warning limit „OverTemp“
Low temperature warning limit „SubTemp“
IN_SP_05 none Setpoint temperature of the external programmer
Temperature indicatio in °C or °F
IN_SP_07 none 1. Adjusted pump stage in the -OFF- condition.
2. Pump stage corresponding to the effective rotation speed
Value of a flowrate sensor connected to the E-Prog input
Temperature difference between working sensor and safety sensor
IN_PAR_01 none Te - Time constant of the external bath.
Ti - Time constant of the internal bath.
IN_PAR_04 none CoSpeed - Band limit (max. difference between the temperatures
in the internal bath and external system).
IN_PAR_05 none Factor pk/ph0:
Ratio of max. cooling capacity versus max. heating capacity
Xp control parameter of the internal controller.
Tn control parameter of the internal controller.
IN_PAR_08 none Tv control parameter of the internal controller.
Xp control parameter of the cascade controller.
Proportional portion of the cascade controller.
To Next Page
Loading...
