Julabo FC1200S - Setting the Setpoint Temperatures; Setting the Temperature

Manual operation
26
6.3. Setting the setpoint temperatures
Set the setpoints before or after starting the unit.
Press the setpoint keys (E, F, G, H) to set a value and
press the Enter key to store the value.
The values will stay in memory when the recirculating
cooler is powered down.
6.3.1. Setting the temperature
Example: Setting the bath temperature
ACTUAL SET
ACTUAL
SET
n Press the setpoint key
.
The indicator light blinks and the value previously
set appears on the MULTI-DISPLAY (LED)
(example: -10.8 °C)..
o Use the cursor keys to move left or right
on the display until the numeral you wish to
change is blinking.
p Use the increase/decrease arrows to
change the selected numeral (-, 0, 1, 2, 3, ... 9).
q Press enter to store the selected value
(example: -8.0 °C).