12 Appendix
108
Relay outputs Status (on/off) for each relay of the external relay module R, S
Mathematical/logic
module
Activate/de-activate the module R, S
Transfer the mathematics program to the instrument S
Interface Report, data format, address, response time for communication via the RS 422 or RS 485
interface
R, S
Logic inputs
-external text
-colour
Text which is printed when a signal is present on the logic input
Colour for printing the text
R, S
S
-binary-linked
external text
-colour
Texts which are printed when certain signal combinations are present on the first four logic
inputs
Colour for printing the text
R, S
S
-external stop A defined logic input stops the recording when a signal is present R, S
-external speed A defined logic input causes a switch to a specific chart speed R, S
-event counter
-colour
Level changes on a logic input can be counted and documented
Colour for printing the event counter results
R, S
S
-external scaling A logic input can be used to initiate the scale printing for all the active channels R, S
-external report Produces a statistical report via a logic input R, S
-keypad inhibit Inhibits all the keys through a logic input R, S
Event traces
-track offset
-colour
Display logic inputs as signal traces
Start position on the chart
Colour of the trace
R, S
S
S
Instrument operation Determine which parameters are required for the application, limit the parameter set S
Parameter Description Programming
S = via setup
R = on recorder
To Next Page