4.7.2 Display Messages
HELP 1 The weighing system has been overloaded.
NOTICE
The weight to be weighed exceeds the maximum setting. To avoid damage,
immediately relieve the weighing system of the load.
HELP 2 Negative signal from the load cells to the AD converter / inclination.
HELP 3 Negative signal from the load cells to the AD converter / inclination.
HELP 4 The tare weight entered is too high.
Z
Press key (36) to clear the display message. Enter a lower tare weight.
HELP 7 The signal from the load cells to the AD converter is too high.
LOW BAT The charge status is too low. The batteries must be replaced (AMW
22). The battery module must be charged (AMW 22p).
61
11.19 en-GB
To Next Page
Loading...
Need help?
General
