To Next Page

To Previous Page

C 1

0600.GB

C Transportation and commissioning

1 Transportation by crane

Only use lifting gear of adequate capacity

(loading weight = dead weight + battery weight; see truck identification plate).

A lifting eye (1) is provided on the fork side of the mast for loading the truck using

crane gear.

- Park the truck and render it safe

(see chapter E, section 4.5).

- Attach the crane gear to the lifting eye (1).

The crane gear must be attached to the lifting eye

in such a manner that it cannot slip!

The crane gear must be attached in such a

manner that it does not touch any attachments

during lifting.

2 Commissioning

The truck must only be operated on battery

current! Rectified alternating current will damage

the electronic components. Cables connected to

the battery (trailing cables) must be less than 6 m

in length.

To prepare the truck for operation after delivery or

transportation, the following operations must be

performed:

- Check the equipment for completeness.

- If necessary, install the battery. Make sure that the battery cable is not damaged.

- Charge the battery (see chapter D, section 3).

- Put the truck into operation in the stipulated manner (see chapter E, section 3).

When the truck is parked, the surface of the tyres may flatten. The flattening will

disappear after the truck has been operated for a short time.

C 1