To Next Page

To Previous Page

D 2

0600.GB

3 Charging the battery using the integrated charger

The mains cable of the charger is accessible from outside.

- Pull the mains plug (1) out of the receptacle (2) on the charger and plug it into a

suitable electric outlet (220 - 240V ±10%). When flashing green (possibly yellow

steady on) the LED (3) indicates that the charger is connected to mains.

- Charge the battery until LED (3) is steady on (green).

- Pull the plug (1) out of the electric outlet and insert it into the receptacle of the safety

circuit on the truck (2).

If the mains plug (1) is not in the receptacle (2) of the safety cut-out, all electrical

functions are interrupted. In this state, the truck cannot be operated.

Trickle charging

The battery is completely charged when the green LED (3) is continuously lit. The

charger switches to trickle charging. Trickle charging continues until the mains plug

is pulled out of the electric outlet.

Mains supply

Mains voltage: 220 - 240 V ±10%

Mains frequency: 50 Hz ±4%

D 2