Jungheinrich EMC 110/B 10 User Manual

E 8
0600.GB
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
- Move the truck so that the load lifting device passes completely below the load.
A
The lifting and lowering speeds are preset.
Lifting
- Press the “Lift load lifting device” button (3) until the required lifting height has been
reached.
m
Immediately release the button when the load lifting device reaches the end stop.
Lowering
- Press the “Lower load lifting device” button (4).
4
10
3
E 8
0600.GB
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
- Move the truck so that the load lifting device passes completely below the load.
A
The lifting and lowering speeds are preset.
Lifting
- Press the “Lift load lifting device” button (3) until the required lifting height has been
reached.
m
Immediately release the button when the load lifting device reaches the end stop.
Lowering
- Press the “Lower load lifting device” button (4).
4
10
3

Jungheinrich EMC 110/B 10 Specifications

General

Brand	Jungheinrich
Model	EMC 110/B 10
Category	Forklifts
Language	English