To Next Page

To Previous Page

D 4

0600.GB

Installation is in the reverse order. When installing the battery, make sure that it is in

the correct position and that the batteries are correctly connected:

- red cable: + terminal of the 1st battery

- blue cable: - terminal of the 2nd cable

- After the battery has been reinstalled, check all cable connections and plugged

connections for visible damage.

5 Battery discharge monitor

The charging condition of the battery is indicated in 10%

increments by a moving bar.

As the battery discharges, the bar moves from right to left.

Battery charging is recommended when the capacity has

dropped to approx. 30%.

At a residual capacity of 20%, the fast speed function is deactivated. The truck can

only be moved at inching speed. The fast speed function will not be released again

until the connected battery has been recharged completely.

Continued operation with the fast speed function deactivated can damage the battery

and leads to the battery being totally depleted. In this state, the battery voltage falls

below the permissible minimum value and charging by means of the charger is no

longer possible (the green LED does not flash when the mains plug is plugged into

the mains outlet). Contact the service department to correct this fault.

D 4