SFP+ Status and Activity LEDs | 142
QSFP+ and QSFP28 Status and Activity LEDs | 143
The QFX10000-60S-6Q line card consists of 60 small form-factor pluggable plus (SFP+) ports, that support
10-Gbps or 1-Gbps port speeds, 2 dual-speed QSFP28 ports that support either 40-Gbps or 100-Gbps
port speed, and 4 QSFP+ ports that support 40-Gbps. All of the QSFP and SFP+ ports are configured to
10-Gbps by default. The QSFP28 ports are configured to 40-Gbps by default, but port 60 and port 65 are
dual-speed ports and can be configured to support either 10-Gigabit Ethernet or 40-Gigabit Ethernet
optical transceivers. Ports 60 and 64 can also be configured to support 100-Gigabit Ethernet optical
transceivers. See the Hardware Compatibility Tool for details of supported optical transceivers.
The QFX10000-60S-6Q line card is supported on Junos OS Release 19.1R1 and later.
NOTE: Junos OS Release 19.1R1 does not support 1-Gigabit Ethernet on the 10-Gigabit Ethernet
SFP+ ports.
This topic describes:
Hardware Features
The line cards in PTX10008 and PTX10016 routers combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that can be installed in the
line card slots on the front of the chassis. The line cards are hot-insertable and hot-removable; you can
remove and replace them without powering off the router or disrupting router functions. See
Figure 61 on page 138.
Figure 61: QFX10000-60S-6Q Port Panel
g050747
1 2
4
3
QFX10000-60S-6Q
3—1— QSFP28 ports, QSFP+ ports, and port groupsPower LED, status LED, and offline button
2—SFP+ ports
138
To Next Page
Loading...
