Juniper QFX5200 - Unpacking and Mounting the QFX5200

QFX5200 Installaon Safety Guidelines
The weight of a fully -loaded QFX5200-32C and QFX5200-32C-L switch chassis is approximately 23.5
lb (10.66 kg); and a QFX5200-48Y weighs between 20.78 lbs (9.43 kg) to 21.16 (9.6 kg) with power
supplies and fans installed. Observe the following guidelines for liing and moving a QFX5200:
CAUTION: If you are installing the QFX5200 above 60 in. (152.4 cm) from the oor,
either remove the power supplies, fan modules, and any expansion modules before
aempng to install the switch, or ask someone to assist you during the installaon.
• Before installing a QFX5200, read the guidelines in "QFX5200 Site Preparaon Checklist" on page 57
to verify that the intended site meets the specied power, environmental, and clearance
requirements.
• Before liing or moving the QFX5200, disconnect all external cables.
• As when liing any heavy object, li most of the weight with your legs rather than your back. Keep
your knees bent and your back relavely straight and avoid twisng your body as you li. Balance
the load evenly and be sure that your foong is solid.
RELATED DOCUMENTATION
QFX5200 Site Guidelines and Requirements | 65
Installaon Instrucons Warning | 174
General Safety Guidelines and Warnings | 169
Unpacking and Mounng the QFX5200
IN THIS SECTION
Unpacking a QFX5200 | 97
Register Products—Mandatory to Validate SLAs | 99
Mounng a QFX5200 in a Rack or Cabinet | 99
96