Register Products—Mandatory to Validate SLAs
Register all new Juniper Networks hardware products and changes to an exisng installed product using
the Juniper Networks website to acvate your hardware replacement service-level agreements (SLAs).
CAUTION: Register product serial numbers on the Juniper Networks website and
update the installaon base data if there is any addion or change to the installaon
base or if the installaon base is moved. Juniper Networks will not be held accountable
for not meeng the hardware replacement service-level agreement for products that do
not have registered serial numbers or accurate installaon base data.
Register your product(s) at hps://tools.juniper.net/svcreg/SRegSerialNum.jsp.
Update your installaon base at hps://www.juniper.net/customers/csc/management/
updateinstallbase.jsp.
Mounng a QFX5200 in a Rack or Cabinet
IN THIS SECTION
Before You Begin Rack Installaon | 99
Four Post Installaon Procedure for QFX5200-32C or QFX5200-32C-L | 101
Four Post Installaon Procedure for QFX5200-48Y | 102
You can mount all QFX5200 switches on a four post 19-in. rack or cabinet using the mounng kit
provided with the switch.
For four post rack or cabinet installaons, the mounng kit contains two front mounng rails with two
matching rear mounng blades. This conguraon allows either end of the switch to be mounted ush
with the rack and sll be adjustable for racks with dierent depths.
(The remainder of this topic uses “rack” to mean “rack or cabinet.”) The front and rear rack rails must be
spaced between 23.5 in. (59.7 cm) and 30.6 in. (77.7 cm) front to back.
This topic describes:
Before You Begin Rack Installaon
Before you begin mounng a QFX5200 switch in the rack or cabinet:
99